Page 1 of 1

font stritching

Posted: Tue Sep 12, 2017 8:47 am
by Mquinton
I have a Tajima single head. I am trying to stitch names but I am finding that the wider areas in the letters will not stitch. I was told not to make the columns in letters wider than 25mm. I was able to change the stitch type from satin to a fill style. Can I do that with essentials? If not can I in Stitch Artist 1
Thanks for you the software.

Re: font stritching

Posted: Sat Sep 23, 2017 6:23 pm
by Wilder
Good day! You would be able to do what you are looking for in Enthusiast. This editing software contains stitch editing which will allow you to change the stitch type or change the number of columns in the satin stitch. With Stitch Artist 1 you would need to create the text needed for your project. It is not impossible but you need to be sure that digitizing is for you. I hope this helps!