Page 1 of 1

Density of Stitches

Posted: Wed Aug 27, 2014 3:47 pm
by goodlysum
Hello! Is there a way of increasing the density of stitches in a monogram design on Alphatricks? When I stitch out a monogram sometimes, the stitches are not close enough together and the fabric below shows through. Thank you in advance!

Re: Density of Stitches

Posted: Wed Aug 27, 2014 4:30 pm
by EastWitch2
goodlysum wrote:Hello! Is there a way of increasing the density of stitches in a monogram design on Alphatricks? When I stitch out a monogram sometimes, the stitches are not close enough together and the fabric below shows through. Thank you in advance!
Hi goodlysum!

No there is no way of adjusting the density of stitches in Alpha Tricks.
You would need The Embilliance Enthusiast program to be able to do this.

You could try using a Topper product such as Dry Cover Up or Cover Up to totally block out your fabric and hold your stitches above it.

The other option is if this was a purchased Alphabet you are using
then perhaps the Digitizer would be able to adjust the density for you.

EastWitch2