Discussion about Embrilliance Enthusiast
1 post • Page 1 of 1
I tried using the knockdown sts on an applique & it laid down sts (on the screen) under the entire design, even where the satin outline sts will go. I just want the areas where there is no design to be knocked back.. I tried moving the knockdown sts to stitch last thinking that would help, but I could not change the order . It looks like the knockdown sts are going to create a very dense area for the design sts to stitch over. Is there away to create a stippling sts instead current stsor change the density of the knockdown sts? I thought the knockdown sts would only go in areas where there was no design present ... or does Embrilliance remove the understitching in design areas before saving ... if so how do I check this?.
Who is online
Users browsing this forum: No registered users and 4 guests