Discussion about Embrilliance Enthusiast
3 posts • Page 1 of 1
Llamalover wrote:I opened a design, clicked to open Enthusiast, and tried to move the compensate bar. Every time I did this the whole program crashed. I had recently added Stitch Artist, but haven't opened it yet. I work on a Mac.
You may want to read through this post at the link below where Lisa explains how to select part or all of a design object and how to use the Compensation Slider Bar in order to make adjustments to the design.
http://www.embrilliance.com/phpBB3/view ... f=26&t=624
If using this method does not work and your program still shuts down then you should contact the Embrilliance Support Team by filling out a Support Ticket at the link below.
Give them as much information as possible and let them know what is happening with your program and they will work with you to solve the problem.
Who is online
Users browsing this forum: No registered users and 3 guests