Naming fonts that contain half an inch

Post Reply
Geri
Posts:1
Joined:Wed Jan 22, 2014 12:01 am
Naming fonts that contain half an inch

Post by Geri » Wed Jan 22, 2014 12:10 am

I have downloaded and mapped several sizes of the same font. In the Name section I have tried to differentiate them by putting Ellie 1 inch and Ellie 1.5 but when I look for them on the list it does not contain the 1.5 or 2.5 instead it says Ellie 1 or Ellie 2. How can I name my fonts that contain a half of an inch? Is there another way to denote a half inch? Hope that this makes sense to someone. Thanks in advance for your help.
Geri

EastWitch2
Posts:755
Joined:Thu Apr 25, 2013 5:14 pm

Re: Naming fonts that contain half an inch

Post by EastWitch2 » Wed Jan 22, 2014 3:18 pm

Hi Geri

You could try naming the 1.50 as just 150 inches or just 150 after the name.
I have several Alphabets that came in lots of sizes such as .25, .50, .75. 1, 1.25, 1.50 , 2 inches etc.
I found I just used the number without the decimal in it after the name and it worked and shows up in the list.

EastWitch2

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests