See your questions answered, and others can learn those answers too.
2 posts • Page 1 of 1
Can't get my designs to save on USB. Not trying to come of as bi___chy, I am just so frustrated. I just want the actual 1,2,3 steps, not all the things that I might have messed up so it wouldn't work. I have 6 design pages saved I want to use. All of them are saved the EXACT same way, but my machine will only read one of them even though they all show up on my usb. There has to be an easier way to get them from the design page to the usb than the round about way I had to get them on. I have looked in the manual and read all the posts - no answer.
I have been in your shoes. I transferred my files to the USB. Check the USB and all were on the USB. Went to the machine to load and none transferred. I had to go back to the designs and check each one. Each one of them were a very tiny bit past what my machine hoop size would hold. Even the tiniest amount(.01) over and it will not transfer. Check your size of your designs and reduce the size of the design by a few mm. AS far as the steps to get the design on the USB you must have that down because you go one design on. I just save my design under Save As ( working and stitch) to the file I want to save it in with a new name. Go to that file in my documents, insert USB, drag file to USB file and right click to click on Eject. I am sure this is the long way but it works for me. Hope this helps.
Who is online
Users browsing this forum: No registered users and 7 guests